Skip to content
RAPTORCENTRAL
Mods

Ranger Raptor Tire Size in Inches, Wheel Size and What the Factory Spec Means

Ford fits LT285/70R17 all-terrains, about 33 inches tall, on 17-inch wheels, with beadlock-capable wheels optional. Here is that size decoded into inches, what the LT and load ratings mean, and what to check before you go bigger.

Sourced to Ford spec sheets6 min readRAPTOR CENTRAL
Silver 2023 Ranger Raptor parked in Darlinghurst, New South Wales, front three-quarter kerbside.
Silver 2023 Ranger Raptor parked in Darlinghurst, New South Wales, front three-quarter kerbside.LuvsMG481, CC BY-SA 4.0, via Wikimedia Commons

Ford puts the Ranger Raptor on 17-inch wheels wrapped in LT285/70R17 all-terrain tires, which work out to about 32.7 inches tall, rounded to 33 in Ford's own spec sheet. Beadlock-capable wheels are an available option, not standard. That is the full factory answer. Everything below is what that size code actually means and what changes if you go bigger.

The factory size, decoded

Ford's 2024, 2025, and 2026 technical spec sheets all list the same tire and wheel package: 17-inch wheels, LT285/70R17 all-terrain tires, 33-inch overall diameter, with beadlock-capable wheels offered as an option. That is consistent across all three model years, which is rare for this truck's spec sheet, since payload, fuel capacity, and brake rotor size all shift year to year depending on which PDF you pull.

The tire code itself breaks down like this, and the math is worth showing because it is how you check any tire size, not just this one:

  • LT means light-truck construction, a sidewall and carcass built for a load-carrying vehicle rather than a passenger car. More on that below.
  • 285 is the section width in millimeters, the tire's width at its widest point. Divide by 25.4 to get inches: 285 / 25.4 = about 11.2 inches wide.
  • 70 is the aspect ratio, the sidewall height as a percentage of section width. 70 percent of 285 mm is 199.5 mm, or about 7.85 inches of sidewall.
  • R17 means radial construction on a 17-inch wheel.

Stack two sidewalls on top of a 17-inch wheel diameter and you get the overall tire height: 17 + 7.85 + 7.85 = about 32.7 inches, which we are labeling here as a calculated figure, not a number pulled off a Ford document. Ford rounds that same tire up to 33 inches in its marketing copy and spec sheet. Both numbers describe the same tire. Nobody is wrong, Ford is just rounding.

What LT construction actually buys you

An LT-rated tire runs a heavier internal structure than a passenger (P-metric) tire of a similar size, usually more body plies and a stiffer sidewall, built to carry higher loads at higher pressures without the sidewall flexing itself apart. That is the right call for a truck that tows up to 5,510 lb and carries a payload that Ford's own spec sheets put at 1,375 lb for the 2024, 1,411 lb for the 2025, and 1,373 lb for the 2026 (check the sheet for your model year rather than assuming they match, because they do not). An LT tire also tends to ride stiffer than a comparable P-metric tire at the same pressure, which is part of why the factory all-terrain on this truck feels firm on pavement and settles in once it has load or air pressure dialed in for the terrain.

What pressure to actually run

We are not going to hand you a psi number here, and you should be suspicious of anyone who does without knowing your specific truck's load and tire. The correct pressure is on the tire placard in the driver's door jamb, and it is calibrated to the factory LT285/70R17 at a specific load. If you change tire size, load range, or brand, that placard number is a starting point, not gospel, and you adjust from there based on tread wear and how the sidewall is flexing. Running a factory-pressure truck empty on washboard is part of why Ford's own 33-inch all-terrain setup can skip the rear end around on corrugations when the bed is empty, a characteristic covered in the Ranger Raptor's known-problem list, not a defect.

Bolt pattern and offset: why we are not giving you a number

Ford's published technical spec sheets for the 2024, 2025, and 2026 Ranger Raptor do not list bolt pattern or wheel offset. That is true across all three PDFs, which is unusual, since Ford documents most other chassis dimensions down to the tenth of an inch. We are not going to invent a bolt pattern or an offset number to fill that gap. If you need it, pull the wheel off the truck and read the backside casting, which stamps both, or call a dealer with your VIN. If you are shopping aftermarket wheels, bring the VIN and the stock wheel to the shop rather than trusting a forum thread, because a wrong offset on a truck with this little clearance (10.7 inches minimum running ground clearance, per Ford) can mean a tire rubbing the fender liner or the upper control arm at full compression.

Going bigger: what 35s actually require

A 33-inch tire is what Ford ships. A lot of new owners look at the factory F-150 Raptor running 35s on a 37 Performance Package and assume the Ranger can do the same thing as a straight tire swap. It cannot. The site's Ranger Raptor truck page puts a 35-inch tire upgrade at $900 to $2,600, and that range exists because the job is not a bolt-on: it needs a leveling kit to create clearance, trimming of the inner fender liner so the tire does not rub at full lock and full compression, and a four-wheel alignment afterward because the larger tire changes the suspension geometry enough to throw camber and toe out of spec. Some trucks also need a bump stop change to stop the tire from contacting the liner on hard compression. If you are shopping tires and want a straight comparison of what 35s and 37s give up and gain against each other, the site's 35s vs 37s tradeoff breakdown and the full cost writeup on putting 37s on a Gen 2 Raptor cover the F-150 side of that math in more detail, though the Ranger's smaller chassis and tighter liners mean its own tire ceiling closes in sooner than the full-size truck's does. If you push to 35s, also plan on a speedometer recalibration, since the factory speedo is calibrated to the 33-inch tire and a bigger tire reads low without it.

The site's own guidance for this truck is that most owners should stay on 33s. Staying at the factory LT285/70R17 size keeps the stock gearing, liner clearance and alignment geometry intact, and if you want a different tread pattern, shopping that same size is the simplest route.

Beadlock wheels: what the factory option actually gets you

Ford's spec sheet notes beadlock-capable wheels as optional across all three model years. A beadlock wheel mechanically clamps the tire bead to the wheel with a ring and bolts, which keeps the tire seated at very low pressure, the kind of pressure you'd run in sand or on technical rock to improve traction and ride compliance. It matters a lot less on pavement and at highway pressure, and it adds unsprung weight and a maintenance item (the beadlock bolts need periodic torque checks) that most daily-driven trucks never need. If you are deciding whether the factory option or an aftermarket beadlock wheel made for the Ranger Raptor's bolt pattern is worth it for how you actually use the truck, the site's beadlock wheel explainer covers who actually benefits from one and who is paying for a feature they'll never use. F-150 Raptor wheels use a different bolt pattern and are not a drop-in.

The short version

  • Factory spec, every model year so far: LT285/70R17 all-terrain on a 17-inch wheel, about 32.7 inches tall by the arithmetic, 33 inches by Ford's own rounding, with beadlock-capable wheels optional.
  • LT means a heavier-duty light-truck carcass built for load and towing, not a comfort tire.
  • Run the pressure on your door-jamb placard, not a number from this article or any other.
  • Bolt pattern and offset are not in Ford's spec sheets. Read the wheel or call the dealer with your VIN.
  • 35s need a level, liner trim, and an alignment, budget $900-2,600. They are not a bolt-on, no matter what the F-150 Raptor crowd tells you.
  • For full specs by year, see the 2024, 2025, and 2026 spec pages.

Deal alert

Shopping for one? Get new listings first

We sweep US dealer inventory and send you new Raptors matching your search — real listings, real asking prices, no spam.

Free · unsubscribe any time
RAPTOR CENTRAL$500PARTS GIFT CARD

Just for signing up: you’re entered to win a $500 Raptor parts gift card. Official rules